Table of Contents
Advertisement
To reset a specific remote shelf, use the -s option and specify the shelf's ID. For
example, the following command resets shelf 3:
HOST> reset –s 3
In an open session to a remote shelf, the -m and -s options are not supported.
Executing a reset on a remote shelf resets only that shelf.
Monitoring remote LIMs and connections
Some Stinger administrative commands have been modified to support a
shelf-specific option, to allow you to focus on a particular remote shelf rather
than obtain a large output for all interfaces or connections in the hosted system.
Where appropriate, output of these commands now shows the shelf number,
along with slot and port.
Displaying status of remote DSL lines
The following new options have been added to Stinger commands for monitoring
LIMs, to specify a shelf, or a shelf and slot combination on the command line:
-sh shelf
-sl shelf slot
These options are not order-dependent, they can appear before or after other
options when entering the following commands:
Displaying shelf-specific ATM connection and signaling information
The following new option has been added to Stinger commands for displaying
ATM connection and signaling details:
-sh shelf
This option applies to the following commands:
You can also specify a shelf number with the existing -s (slot), -p (port), or
-d (details) options to these commands. If no shelf number is specified, shelf 1 is
Stinger® MRT Getting Started Guide
dsllines
dmtaldsllines
hdsl2lines
sdsllines
shdsllines
vdsllines
atmvcl
atmvpl
atmvcx
atmvpx
spvcc
spvpc
spvcshow
atmsig
Hosted Operation of Cascaded Stinger MRT units
Hosted MRT system management
B-15
Advertisement
Table of Contents
