Table of Contents
Advertisement
!
Caution
3
Repeat step 1 and step 2 to install the second mounting bracket onto the other
side of the unit.
Mounting brackets for the Stinger MRT 19
Mounting brackets are available for installing the Stinger MRT 19 chassis horizontally
in standard 23-inch (58.42cm) racks, 19-inch (48.26cm) EIA Equipment racks, and
ETSI cabinets that have a minimum of 17.72 inches (45.0cm) of space between the
mounting rails.
23-inch mounting brackets for the Stinger MRT 19
The Stinger MRT 19 can be mounted horizontally in a 23-inch rack, using chassis
mounting points at the front and midpoint of the Stinger MRT 19 chassis. Use the
supplied screws to attach the brackets to the Stinger MRT 19 chassis.
Figure 3-5. 23-inch rack mounting brackets for the Stinger MRT 19
0.984 in.
(25mm)
Warning
!
cabinet top-heavy or unstable. Take all necessary precautions to anchor the cabinet
securely before installing the unit.
Installing the 23-inch mounting brackets on the Stinger MRT 19
The 23-inch mounting brackets for the Stinger MRT 19 can be installed to align the
front or mid-point of the chassis with the rails of the 23-inch rack. This is
accomplished by rotating the brackets to position them as shown in Figure 3-6.
To install the mounting brackets onto the unit:
1
Rotate the brackets to align the front or midpoint of the Stinger MRT 19 chassis
with the mounting rails of the equipment rack, as shown in Figure 3-6.
Stinger® MRT Getting Started Guide
Failure to use the proper screws might damage the unit.
The weight and position of hardware within the cabinet might make the
Installing a Stinger MRT
Identifying and installing mounting brackets
0.984 in
(25mm)
3-5
Advertisement
Table of Contents
