Displaying Shdsl Port Status - Lucent Technologies Stinger MRT 19 Getting Started Manual

Configuring the SHDSL line interfaces
Configuring SHDSL interfaces
admin> set line-config master-binding-port = yes
admin> set line-config unit-type = coe
admin> write
admin> read shdsl {1 3 6}
admin> set enabled = yes
admin> write
For the SHDSL Stinger MRT:
admin> read shdsl {1 1 1}
admin> set enabled = yes
admin> set line-config rate-mode = fixed
admin> set line-config master-binding-port = yes
admin> set line-config unit-type = cpe
admin> write
admin> read shdsl {1 1 2}
admin> set enabled = yes
admin> write

Displaying SHDSL port status

To display the port status and nailed group for each SHDSL port, use the shdsllines
command. For a description of the command's syntax, enter the command name, as
in the following example:
admin> shdsllines
usage: shdsllines -[ a | d | f | u | t ]
-a show (a)ll shdsl lines
-d show (d)isabled lines
-f show all (f)ree lines
-u show in-(u)se lines
-t toggle debug flag
The following example (which is truncated) shows status of the first 16 ports on an
SHDSL Stinger MRT:
admin> shdsllines -a
All SHDSL lines:
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
Line
8-10
(dvOp
{ 1 1 1 } (Down
{ 1 1 2 } (Down
{ 1 1 3 } (Up
{ 1 1 4 } (Down
{ 1 1 5 } (Down
{ 1 1 6 } (Down
{ 1 1 7 } (Up
{ 1 1 8 } (Down
{ 1 1 9 } (Up
{ 1 1 10 } (Up
{ 1 1 11 } (Down
{ 1 1 12 } (Down
{ 1 1 13 } (Up
{ 1 1 14 } (Down
{ 1 1 15 } (Down
{ 1 1 16 } (Down
dvUpSt dvRq sAdm
Idle DOWN DOWN
Idle DOWN DOWN
Idle UP UP
Idle DOWN DOWN
Idle DOWN DOWN
Idle DOWN DOWN
Idle UP UP
Idle DOWN DOWN
Idle UP UP
Idle UP UP
Idle DOWN DOWN
Idle DOWN DOWN
Idle UP UP
Idle DOWN DOWN
Idle DOWN DOWN
Idle DOWN DOWN
Stinger® MRT Getting Started Guide
nailg)
00151)
00152)
00153)
00154)
00155)
00156)
00157)
00158)
00159)
00160)
00161)
00162)
00163)
00164)
00165)
00166)