Lucent Technologies Stinger MRT 19 Getting Started Manual page 123

gshdsl-psd-type = symmetric
master-binding-port = no
Parameter
trunk-group
nailed-group
vp-switching-vpi
activation
call-route-info
unit-type
ntr-enabled
clock-source
Stinger® MRT Getting Started Guide
Setting
Not currently used. Use the default value (zero).
Nailed-group number for the SHDSL physical interface. A
connection or RADIUS profile specifies this number to
make use of the interface.
Each interface is assigned a unique default number, so you
need not modify this parameter. If you assign a new value,
it must be a number from 1 through 1024 that is unique
within the system.
The virtual path identifier (VPI) to use for virtual path
switching on the port. The default is 15. All other VPIs are
used for virtual circuit (VC) switching.
Not currently used. Leave the default value (static).
Not currently used. Leave the default value (the zero address).
Type of unit. Remote equipment must have opposite
setting. Specify one of the following values:
coe (the default)—The unit is central office equipment
(COE).
cpe—The unit is customer premises equipment (CPE).
Enable or disable network time reference (NTR) capability.
Specify one of the following values:
no (the default)—NTR capability is disabled.
yes—NTR capability is enabled.
If the unit-type parameter is set to coe, the system clock is
taken as the input and the CPE, if equipped to do so, can
recover the clock.
If the unit-type parameter is set to cpe, the port outputs the
recovered clock as the system clock if the clock-source
parameter is set to eligible and the clock-priority
parameter is set to allow the clock to be selected.
Eligibility of the 8kHz clock from the SHDSL line to be used
as the 8kHz system clock. Specify one of the following
values:
eligible—The line can be used as the master clock
source. The unit-type parameter must be set to cpe.
The ntr-enabled parameter must be set to yes.
not-eligible—The line cannot be used as the master
clock source.
Configuring the SHDSL line interfaces
Configuring SHDSL interfaces
8-3