Table of Contents
Advertisement
dircode
ether-display
fatal-history
format
fsck
get
hdlc
[More? <ret>=next entry, <sp>=next page, <^C>=abort]
For details about each command, see the Stinger Reference. For more information
about command help, see the TAOS Command-Line Interface Guide.
The command-line interface supports several status windows that focus on different
aspects of system activity (such as connection status and log messages). The windows
provide a great deal of read-only information about what is currently happening in
the unit. To display a status window, enter the Status command:
admin> status
The system prompt moves to just below the status window. To close the status
window, enter the command again:
admin> status
If the system prompt is not visible below the status window, press Escape to display it.
Note
Stinger MRT configuration settings are stored in onboard flash memory, and
must be backed up to a TFTP host whenever changes are made. For details about
backing up and restoring the Stinger MRT configuration, see the Stinger Administration
Guide.
What's next
When you have planned your network, you are ready to configure the Stinger MRT
unit. You can perform configuration tasks in any order you want. Table 5-1 shows
where to look for the information you need.
Table 5-1. Location of configuration information
Configuration task
Establish a serial connection
Set up basic access security
Configure IP
Configure the unit to use
RADIUS
Configure the unit's lines
Stinger® MRT Getting Started Guide
Stinger MRT Operational Overview
( system )
( diagnostic )
( system )
( code )
( code )
( system )
( system )
Location
"Making the initial administrative connection" on
page 6-2
"Restricting administrative access" on page 6-3
"Providing a basic system IP configuration" on
page 6-6
TAOS RADIUS Guide and Reference
Chapter 7, "Configuring the ADSL Line
Interfaces."
Chapter 8, "Configuring the SHDSL line
interfaces."
What's next
5-7
Advertisement
Table of Contents
