Interpreting Oc3-Atm Status Lights - Lucent Technologies Stinger MRT 19 Getting Started Manual

Configuring an OC3-ATM Trunk Module

Interpreting OC3-ATM status lights

Caution
!
cable into circular coils.
Note Clean any fiber optic cables prior to connecting them.
To connect the cables to an OC3-ATM trunk module, align the small rectangular key
on the head of the cable with the slot in the trunk module connector and carefully
insert the head of each cable into the proper connector on the trunk module, as
shown in Figure 10-1.
Figure 10-1. Connecting an OC3-ATM trunk module for an MRT 23
Figure 10-2. Connecting an OC3-ATM trunk module for an MRT 19
Inform your service provider that the equipment is connected so the provider can
activate the line.

Interpreting OC3-ATM status lights

Each port of the OC3-ATM trunk module has two status lights, as shown in
Figure 10-3 and described in Table 10-1.
Note The OC3-ATM module depicted in Figure 10-3 is for an MRT 23. The status
lights are positioned differently on an OC3-ATM module for the MRT 19, but indicate
the same conditions on both modules.
10-2
Bind excess cable lengths in a figure-eight pattern. Do not wind excess
SD
LOS
PORT 1
PORT 2
SD
LOS
PORT 2
LOS
LOS
SD
SD
PORT 1
Stinger® MRT Getting Started Guide