Lucent Technologies Stinger MRT 19 Getting Started Manual page 161

Parameter
check-far-end-ima-id
expected-far-end-ima-id
far-end-check-frame-
length
expected-far-end-frame-
length
atm-if-delay
tpp-test-link
tpp-test-pattern
Stinger® MRT Getting Started Guide
Configuring T1 and E1 Trunk Modules
Setting
Specifies whether the verification of the far-end IMA
ID during group startup is enabled or disabled.
Valid values are as follows:
Yes—Specifies that this check is enabled.
No—Specifies that this check is not enabled. This is
the default.
Specifies a number to check against the IMA ID at the
far end. If the parameter check-far-end-ima-id is set
to yes, then the far-end IMA ID is compared against
this number (the expected far-end IMA ID) during
group startup, and the unit moves to the
ConfigAborted state if there is no match.
Specify a number from 0 (zero) through 255.
Specifies whether to check or compare the expected
frame length with the far-end frame length during
group startup.
Valid values are as follows:
Yes—Specifies that this check is enabled.
No—Specifies that this check is not enabled. This is
the default.
Specifies a number to check against the IMA ID at the
far end. If the parameter check-far-end-ima-id is set
to yes, then the far-end IMA ID is compared against
this number (the expected far-end IMA ID) during
group startup, and the unit moves to the
ConfigAborted state if there is no match.
Specify a number from 0 (zero) through 255.
Specifies the minimum time in seconds for IMA data
cell rate (IDCR) changes between the subsequent
ATM layer.
The valid range is from 0 (zero) through 2147483647.
Specifies a Simple Network Management Protocol
(SNMP) interface as the test link for use in the test
pattern procedure.
The valid range is from -1 through 24.
Indicates a number that specifies the test pattern
transmitted in the IMA Control Protocol (ICP) cell
(octet 17) on the link during the IMA test pattern
procedure.
The valid range is from -1 through 255.
IMAgroup profile
9-19