Table of Contents
Advertisement
Installing the EIA mounting brackets on the Stinger MRT 19
The EIA mounting brackets for the Stinger MRT 19 can be installed to align the front
or the mid-point of the chassis with the rails of the equipment rack. This is
accomplished by attaching the brackets to the front or mid-point mounting holes of
the chassis, as shown in Figure 3-10.
To install the mounting brackets onto the unit:
1
Position the brackets to align with the mounting holes at the front or midpoint of
the Stinger MRT 19 chassis.
2
Place a mounting bracket onto one side of the Stinger unit, lining up the two
screw holes on the bracket with two bracket holes on the side of the unit. You
can use the bracket holes near the front of the unit or near the midpoint of the
unit, as shown in Figure 3-10.
Figure 3-10. Installing EIA brackets on the MRT 19
3
Using a number 2 Phillips screwdriver, install the 1/4-inch flathead screws
(supplied with the brackets) through the mounting bracket holes into the unit, as
shown in Figure 3-10.
!
Caution
4
Repeat step 1 and step 2 to install the second mounting bracket onto the other
side of the unit.
Mounting the MRT in an equipment rack
Once the appropriate mounting brackets have been installed on a Stinger MRT 23 or
Stinger MRT 19 chassis they can be mounted in an equipment rack or cabinet.
Position the unit for installation, keeping in mind that cables connect to the front of
the unit.
Note
The procedure for installing the unit into a cabinet requires that you supply a
minimum of four cross-head screws of the appropriate size to support the unit in the
cabinet rack.
Stinger® MRT Getting Started Guide
Failure to use the proper screws might damage the unit.
Installing a Stinger MRT
Mounting the MRT in an equipment rack
Midpoint position
Front position
48 V A
RT N
RT N
48 V B
A
B
LO S
SD
PO R T
2
PO R TS
24
PO R T
10
6
5
E X
1
ST AT U
S
LO S
G R O U
P
SE L
SD
1
PO R T
3-9
Advertisement
Table of Contents
