Lucent Technologies Stinger MRT 19 Getting Started Manual page 164

Configuring T1 and E1 Trunk Modules
IMA-Group-Stat profile
valid-intervals = 0
invalid-intervals = 96
vpi-vci-range = vpi-0-255-vci-32-2047
vc-switching-vpi = ""
ima-group-statistic = { 0 0 0 }
Parameter
name
physical-address
near-end-ima-group-state
far-end-ima-group-state
failure-status
far-end-txclock-mode
tx-timing-ref-link
9-22
Setting
Name of the IMAgroup profile.
Identifies the physical address of an interface.
The physical address has the format {shelf slot
item}.
shelf is the shelf in which the item resides. Since
a Stinger MRT unit is a single-shelf system, the
shelf number is always 1.
slot is the number of the item's expansion slot.
The trunk module of the Stinger MRT is referred to
as slot 18.
item is the number of the group. Groups are
numbered from 9 to 12 by the TAOS operating
system. For example, the first IMA group on a T1
module in a Stinger MRT has the following
address:
{ 1 18 9 }
Indicates the current operational state of the near-end
IMA group.
Indicates the current operational state of the far-end
IMA group.
Indicates the current failure status of the IMA group
(the reason why the group has failed).
Indicates the transmit clocking mode used by the
far-end ATM group.
Valid values for this parameter are as follows:
ctc—Common transmit clock: transmit clocks of
the links within the IMA group derived from the
same clock source.
itc—Independent transmit clock: transmit clock of
the links within the IMA group derived from their
respective receive clocks.
Indicates the index of the transmit timing reference
link to be used by the near end for IMA data cell clock
recovery from the ATM layer.
Valid values for this parameter range from 0 (zero)
through 24. The distinguished value of zero is used if
no link has been configured in the IMA group, or if the
transmit timing reference link has not yet been
selected.
Stinger® MRT Getting Started Guide