Sample Shdsl Mode Configuration; Binding Two Shdsl Ports - Lucent Technologies Stinger MRT 19 Getting Started Manual

Sample SHDSL mode configuration

Following is an example of an shdsl profile configured for typical use:
admin> read shdsl { 1 1 1}
SHDSL/{ shelf-1 slot-1 1 } read
admin> list
[in SHDSL/{ shelf-1 slot-1 1 }]
name = 1:1:1
physical-address* = { shelf-1 slot-1 1 }
enabled = yes
sparing-mode = inactive
line-config = { 0 101 15 static { any-shelf any-slot 0 } coe no
not-eligible mi+
admin> list line
[in SHDSL/{ shelf-1 slot-3 1 }:line-config]
trunk-group = 0
nailed-group = 1
vp-switching-vpi = 15
activation = static
call-route-info = { any-shelf any-slot 0 }
unit-type = coe
ntr-enabled = no
clock-source = not-eligible
clock-priority = middle-priority
loop-back = none
margin = 2db
snext-margin = disable
rate-mode = auto
min-rate = 72000
max-rate = 2312000
gshdsl-standard-network-type = north-american-annex-a
annexb-anfp-enabled = no
gshdsl-psd-type = symmetric
master-binding-port = no

Binding two SHDSL ports

Port binding allows the combining of two adjacent ports to double the available
bandwidth. The port pairs on both the COE and CPE sides must support port binding.
Stinger-to-Stinger connections can be supported by setting one pair of ports to a
unit-type of coe and the other to a unit-type of cpe.
In this example, we connect a Stinger FS+ to a SHDSL Stinger MRT using port
binding to support greater bandwidth. We bind ports 5 and 6 on the SHDSL LIM in
slot 3 on a Stinger FS+ and ports 1 and 2 on a SHDSL Stinger MRT. Note that the
slave ports automatically assume the settings from the master ports:
For the Stinger FS+:
admin> read shdsl {1 3 5}
admin> set enabled = yes
admin> set line-config rate-mode = fixed
Stinger® MRT Getting Started Guide
Configuring the SHDSL line interfaces
Configuring SHDSL interfaces
8-9