Installing a Stinger MRT
Replacing the cooling module on the Stinger MRT 19
Caution
!
extend from the left side of the connectors. These cables must be routed to the left
side of the chassis to avoid blocking air-flow from the cooling module.
Fans used for cooling the MRT 23 are not field replaceable.
Replacing the cooling module on the Stinger MRT 19
Use the following procedure to replace the cooling module on a Stinger MRT 19.
1
Put on the antistatic wrist strap and connect it to ground potential.
2
Loosen the locking screws on both sides of the old cooling module and pull old
cooling module from the chassis, as shown in Figure
Figure 3-15. Removing the cooling module of a Stinger MRT 19
4 8
1 0 B T
3
Align the slot on the bottom of the new cooling module with the alignment studs
inside the bottom of the Stinger MRT 19 chassis and slide new cooling module
straight into the Stinger MRT chassis, as shown in Figure 3-16.
4
Firmly press the module completely into the chassis to engage the power
connector on the module with the connector in the chassis.
3-14
50-pin connectors used on the Stinger MRT 19 must have cables that
2 5
P O R T S
S H E L F
M A J O R
B IT S
ID
A L A R M
M IN O R
O L E
C O N S
Cooling module lock screws
M R T
C O O LI N
G
S
M S TA TU
S Y S TE
Stinger® MRT Getting Started Guide