Lucent Technologies Stinger MRT 19 Getting Started Manual page 154

Configuring T1 and E1 Trunk Modules
DS1-ATM-Stat profile
Parameter
line-mode
line-state
loss-of-carrier
loss-of-sync
ais-receive
9-12
Setting
slot is the number of the item's expansion slot.
The trunk module of the Stinger MRT is referred
to as slot 18.
item is the item on the module. Items are
numbered starting with 1 for the leftmost item
on the module. An item number of 0 (zero)
denotes the entire slot. For example, line 4 on a
T1 module has the following address:
{ 1 18 4 }
Indicates whether the mode in which this line is
operating is user-to-network-interface (UNI) or
inverse multiplexing over ATM (IMA).
Valid values are as follows:
uni— Link operates in UNI mode.
ima—Link operates in IMA mode.
Indicates the overall state of a line. The Line-State
setting is read only. You cannot set Line-State
directly.
Indicates a loss of carrier on the DS1-ATM line.
Valid values are as follows:
false—Indicates no loss of carrier.
true—Indicates a loss of carrier.
Indicates a loss of synchronization on the DS1-ATM
line.
Valid values for this read-only parameter are as
follows:
true—Indicates a loss of synchronization.
false—Indicates no loss is indicated.
Indicates whether the remote end is sending an
alarm indication signal (AIS) on the line. The remote
end sends an AIS (instead of normal data) to take the
line out of service.
The AIS-Receive setting is read-only. Values are as
follows:
true—Indicates that the remote end is sending
an AIS.
false—Indicates that the remote end is not
sending an AIS.
Stinger® MRT Getting Started Guide