Lucent Technologies Stinger MRT 19 Getting Started Manual page 91

[in CONNECTION/"":ip-options]
ip-routing-enabled = yes
remote-address = 3.3.3.3/24
[in CONNECTION/"":atm-options]
atm1483type = aal5-llc
vpi = 0
vci = 35
nailed-group = 1
cast-type = p2p
conn-kind = pvc
vp-switching = no
[in CONNECTION/"":atm-qos-options]
usr-up-stream-contract = ""
usr-dn-stream-contract = ""
Parameter
station
active
encapsulation-protocol
ip-options:
ip-routing-enabled
ip-options:
remote-address
atm-options:
atm1483type
atm-options:vpi
atm-options:vci
atm-options:
nailed-group
atm-options:
atm-options:
Stinger® MRT Getting Started Guide
Configuring Administrative Access, System Timing, and Startup Settings
Additional administrative connections and configuration
Setting
Name of the far-end device.
Enable/disable the profile for active use.
Encapsulation protocol to use for the connection. This
parameter must be set to atm for terminating
connections.
Enable/disable IP routing for the interface. IP routing
must be enabled (as it is by default) for terminating
connections.
IP address of the far-end device, which can include a
subnet specification. If it does not include a subnet
mask, the router software in the Stinger MRT unit
assumes a default subnet mask that is based on address
class. (For related information, see "Netmasks" on
page 6-6.)
Method of multiplexing Layer-3 packets into ATM cells.
Valid values are AAL5-LLC and AAL5-VC.
VPI for the connection. For a discussion of valid VPI
values, see the Stinger ATM Configuration Guide.
VCI for the connection. For a discussion of valid VCI
values, see the Stinger ATM Configuration Guide.
Number of the dedicated (nailed) group for the physical
interface used by the connection. (Use the which
command to display a port's nailed-group number. For
details, see the Stinger ATM Configuration Guide.)
Connection topology type. Only the default
cast-type
point-to-point (p2p) value is valid.
Kind of connection. Because the Private
conn-kind
Network-to-Network Interface (PNNI) protocol is not
supported on the Stinger MRT at this time, pvc (the
default) is the only valid setting.
6-15