Checking The Status Of A Terminating Pvc - Lucent Technologies Stinger MRT 19 Getting Started Manual

Configuring Administrative Access, System Timing, and Startup Settings
Additional administrative connections and configuration
Following is a comparable definition in a RADIUS profile:
permconn-ST-1 Password = "ascend"
Service-Type = Outbound,
Framed-Protocol = ATM-1483,
User-Name = "dsltnt-1",
Framed-IP-Address = 3.3.3.3,
Framed-IP-Netmask = 255.255.255.0,
Ascend-ATM-Group = 802,
Ascend-Route-IP = Route-IP-Yes,
Ascend-ATM-Vci = 101,
Ascend-QOS-Upstream = "cbr",
Ascend-QOS-Downstream = "cbr"
Sample far-end DSLTNT configuration
In this example, the DSLTNT® unit has a DS3 interface to the ATM network. The
following command displays the nailed-group value assigned to the DS3-ATM
interface used for this connection:
admin> get atm-ds3 {1 7 1} line-config nailed-group
[in ATM-DS3/{ shelf-1 slot-7 1 }:line-config]
nailed-group = 70
The following commands on the DSLTNT® unit configure a connection profile for the
Stinger MRT connection using the unit's IP address and VCI 101:
admin> get connection stinger-1
CONNECTION/stinger-1 read
admin> set active = yes
admin> set encapsulation = atm
admin> set ip-options remote-address = 1.1.1.128/24
admin> set telco-options call-type = ft1
admin> set telco-options nailed-group = 70
admin> set atm-options vci = 101
admin> write
CONNECTION/stinger-1 written
For more details about creating connection profiles on DSLTNT® units, see the
DSLTNT® documentation.

Checking the status of a terminating PVC

For examples of commands you can use to check connection status of virtual links
and connections, see the Stinger ATM Configuration Guide. The same commands apply
to terminating or cross-connected PVCs.
For terminating PVCs, the values in the atmvcc-stat and atmpvc-stat profiles are
slightly different for terminating connections. Following are the relevant parameters
(shown with sample settings):
[in ATMVCC-STAT/{ shelf-1 slot-17 1 0 35 }]
vcc-ident* = { shelf-1 slot-17 1 0 35 }
circuit-name = dsltnt-1
6-18 Stinger® MRT Getting Started Guide