Interleave-Path-Config Subprofile - Lucent Technologies Stinger MRT 19 Getting Started Manual

Configuring the ADSL Line Interfaces
Configuring ATM ADSL-DMT interfaces
planned-bitrate-up = 512
planned-bitrate-down = 1000
The Interleave-Path-Config profile contains a similar group of parameters. For an
explanation of these parameters, see "Interleave-Path-Config subprofile" on
page 7-8.
Setting the fast-path bit rate for maximum performance
For optimum performance under most conditions, fast-path bit rates can be
configured as shown in the following example, which indicates how the bit rates are
set for the first interface of a Stinger MRT:
admin> read al-dmt {1 1 1}
AL-DMT/{ shelf-1 slot-1 1 } read
admin> set fast-path-config max-bitrate-up = 1280
admin> set fast-path-config max-bitrate-down = 12480
admin> set fast-path-config min-bitrate-up = 32
admin> set fast-path-config min-bitrate-down = 32
admin> write

Interleave-Path-Config subprofile

In the following default configuration of the Interleave-Path-Config subprofile,
bit-rate parameter settings indicate the use of the interleave path channel for both
upstream and downstream traffic:
[in AL-DMT/{ any-shelf any-slot 0 }:interleave-path-config]
min-bitrate-up = 128
min-bitrate-down = 128
max-bitrate-up = 1000
max-bitrate-down = 8000
planned-bitrate-up = 512
planned-bitrate-down = 1000
Parameter
min-bitrate-up
min-bitrate-down
7-8
Setting
Specifies the minimum bit rate for upstream traffic, from
0Kbps to 1024Kbps. When the automatic rate-adaptive
mode is in use, the line initializes at this upstream rate or
fails to initialize.
The default value for the Stinger MRT is 128Kbps.
Note This parameter does not apply when the rate
adaptation is operator-controlled.
Specifies the minimum bit rate for downstream traffic, from
0Kbps to 8192Kbps. When the automatic rate-adaptive
mode is in use, the line either initializes at this downstream
rate or fails to initialize.
The default value for the Stinger MRT is 128Kbps.
Note This parameter does not apply when the rate
adaptation is operator-controlled.
Stinger® MRT Getting Started Guide