Table of Contents
Advertisement
Parameter
line-config:high-
tx-output
line-config:framer-
mode
line-config:receive-
equalization
line-config:vpi-vci-
range
line-config:vc-
switching-vpi
line-config:clock-
source
line-config:clock-
priority
line-config:cell-
payload-scramble
line-config:status-
change-trap-enable
Displaying DS3-ATM port status and nailed groups
To see the nailed-group numbers for trunk ports, use the atmtrunks command. For
example, the command output that follows shows the nailed-group numbers for
DS3-ATM trunks. In this example, the system has one DS3-ATM trunk module
installed in slot 18.
admin> atmtrunks -a
All DS3 ATM trunks:
DS3 Lines
Line
Line
For explanations of command output, see Table 10-2 on page 10-5.
Stinger® MRT Getting Started Guide
Setting
Enable/disable high transmit output. The default is no,
which is correct for DS3 cables that are less than 255 feet
(78m) long. For cables longer than 255 feet, set this
parameter to yes.
DS3-ATM framer mode. Following are valid values:
c-bit-adm
c-bit-plcp
c-bit-adm-loop-timed
c-bit-plcp-loop-timed
c-bit-adm-frame-locked
c-bit-plcp-frame-locked
For more information, see "Setting DS3 framing formats"
on page 11-6.
Set to yes if equalization is needed, otherwise set to no
Valid range of virtual channel identifier (VCI) numbers to
be used with specified virtual path identifier (VPIs) for
virtual channel connections (VCCs).
Array of up to seven VPIs to use for virtual channel (VC)
switching.
Enable/disable obtaining the system clock signal from the
port.
Priority of the interface as the system's clock source.
Set to yes if cell-payload-scrambling is enabled. Otherwise
set this parameter to no
Set to yes to generate an SNMP notification (trap) when the
line changes state. Otherwise set this parameter to no
{
1 18 1 }
(Up
{
1 18 2 }
(Up
Configuring a DS3-ATM Trunk Module
Configuring a DS3-ATM trunk module
(dvOp
dvUpSt dvRq
Idle
UP
Idle
UP
sAdm
nailg)
UP
00851)
UP
00852)
11-5
Advertisement
Table of Contents
