Table B-3 Hosted Mrt Alarm Events - Lucent Technologies Stinger MRT 19 Getting Started Manual

Table B-3. Hosted MRT alarm events
event setting
remote-shelf-state-chang
e
input-relay-closed
input-relay-open
Sample alarm for remote shelf 3 state change
The following commands set an alarm for a change in status of shelf 3:
HOST> new alarm shelf-3
HOST> set enabled = yes
HOST> set event = remote-shelf-state-change
HOST> set physical-address shelf = shelf-3
HOST> write -f
If the alarm is triggered (for example, if shelf 3 becomes unavailable), an
emergency log message is displayed. For example:
LOG emergency, Shelf 1, Controller-1, Time: 14:26:35--
Wed Sep 17 14:26:35 2000 - ALARM: Remote Shelf { 3 } Alarm is: Active
The following alarm command shows that an alarm has been set and the remote
shelf is down:
HOST> alarm -s
Remote Shelf Down
When the shelf changes state again, for example, when it comes up or is disabled
in the remote-shelf-config profile, the alarm is cleared. for example:
LOG emergency, Shelf 1, Controller-1, Time: 14:28:16--
Wed Sep 17 14:28:16 2000 - ALARM: Remote Shelf { 3 } Alarm is: Cleared
HOST> alarm -s
Sample alarm for input-relay closure status on any remote shelf
The following commands configure an alarm for input-relay closure on any
remote shelf in a hosted system:
HOST> new alarm closed
HOST> set enabled = yes
Stinger® MRT Getting Started Guide
Event on remote shelf that triggers alarm
The remote shelf changes state. The new status is
shown in the remote-shelf-oper-state setting of the
remote-shelf-stat profile.
Contact-closure sensors on the remote shelf indicate
closure. The status is shown in the contact-closure[N]
setting of the remote-shelf-stat profile.
Contact-closure sensors on the remote shelf indicate
loss of contact closure. The status is shown in the
contact-closure[N] setting of the remote-shelf-stat
profile.
Type Address
{ 3 }
Type Address
Hosted Operation of Cascaded Stinger MRT units
Hosted MRT system management
State
Active
State
B-19