Table of Contents
Advertisement
Parameter
line-config:loop-
timing
line-config:vpi-vci-
range
line-config:vc-
switching-vpi
line-config:clock-
source
line-config:clock-
priority
Displaying OC3-ATM status and nailed groups
To see the nailed-group numbers for trunk ports, use the atmtrunks command. For
example, the command output that follows shows the nailed-group numbers for all
OC3-ATM trunks.
admin> atmtrunks -a
All OC3 ATM trunks:
OC3 Lines
Line
Line
All DS3 ATM trunks:
DS3 Lines
Table 10-2 explains the output of the atmtrunks command.
Table 10-2. Descriptions of atmtrunks command output
Output column
heading
dvOp
dvUpSt
dvRq
sAdm
Nailg
Stinger® MRT Getting Started Guide
Setting
Enable/disable derivation of transmission (TX) timing from
receiver inputs. Yes causes the TAOS unit to derive TX
timing for all trunk ports from the receiver inputs of the
ports. Loop timing is disabled by default. With the default
setting, transmission timing is derived from the reference
clock.
Valid range of virtual channel identifier (VCI) numbers to
be used with specified virtual path identifiers (VPIs) for
virtual channel connections (VCCs).
Array of up to seven VPIs to use for VC switching.
Enable/disable obtaining the system clock signal from the
port.
Priority for choosing an interface as the system's clock
source.
{
1 18 1 }
(Up
{
1 18 2 }
(Up
Description
Device operational state. The current operational state of the
device, either UP or DOWN.
Device up status. The status of the device, when it is UP.
Device required state. The state in which the device is
required to be.
Administrative state of the device, either UP or DOWN.
Number of the nailed group to which a line is assigned.
Configuring an OC3-ATM Trunk Module
Configuring an OC3-ATM trunk module
(dvOp
dvUpSt dvRq
Idle
UP
Idle
UP
(dvOp
dvUpSt dvRq
sAdm
nailg)
UP
00851)
UP
00852)
sAdm
nailg)
10-5
Advertisement
Table of Contents
