Configuring Administrative Access, System Timing, and Startup Settings
Saving and loading a backup configuration
To restore a configuration from a file on the system you are using for administrative
access to the Stinger unit, enter the following load command, and set your VT100
emulation software to send the saved configuration file.
admin> load config console
Restoring from a network host
To restore a configuration from a file on a network host, enter the load command as
follows:
admin> load config network hostname filename
Replace hostname with the name of the host and filename with the name of the
file in which the configuration is stored.
To load a configuration file named unit.cfg from network host 10.8.7.2 to the
PCMCIA flash card in slot 1, proceed as follows:
admin> load config network 10.8.7.2 /unit.cfg
For more detailed information about Stinger configuration, see the Stinger
Administration Guide.
6-26
Stinger® MRT Getting Started Guide