Monitoring The Oc3 Interface - Lucent Technologies Stinger MRT 19 Getting Started Manual

Monitoring the OC3 interface

The following display shows OC3-ATM-Stat parameters for the physical interface,
with sample settings for an active line:
[in OC3-ATM-STAT/{ shelf-1 trunk-module-2 1 }]
physical-address* = { shelf-1 trunk-module-2 1 }
line-state = active
spare-physical-address = { any-shelf any-slot 0 }
sparing-state = sparing-none
vpi-vci-range = vpi-0-255-vci-32-8191
vc-switching-vpi = 0
vcc-vpi = [ 0 0 0 0 0 0 0 ]
loss-of-signal = False
loss-of-frame = False
out-of-frame = False
section-state = sonet-section-active-no-defect
path-state = sonet-path-active-no-defect
ais-receive = False
yellow-receive = False
out-of-cell-delineation = False
loss-of-cell-delineation = False
aps-receive = False
rsop-bip-error-count = 0
rlop-bip-error-count = 0
rlop-febe-error-count = 0
rpop-bip-error-count = 0
rpop-febe-error-count = 0
racp-chcs-error-count = 0
racp-uchcs-error-count = 12064
racp-rx-cell-count = 32855
tacp-tx-cell-count = 16
frequency-justification-count = 0
HEC-cell-drop-counter = 0
FIFO-overflow-counter = 0
idle-cell-counter = 0
valid-cell-counter = 0
performance-monitoring = { 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 }
interval-performance-monitoring = [ { 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0+
Parameter
physical-address
Stinger® MRT Getting Started Guide
Configuring an OC3-ATM Trunk Module
Checking OC3-ATM trunk interface status
Setting
Physical location of the OC3-ATM line within the
Stinger MRT system.
Note Two OC3-ATM modules appear when an
OC3-ATM trunk module is installed in the Stinger
MRT. The profile for the module indicated as
is for the built-in STS-3 interfaces on
trunk-module-1
the chassis. The profile for the module indicated as
is for the OC3-ATM trunk module in the
trunk-module-2
unit's trunk module slot.
10-7