Lucent Technologies Stinger MRT 19 Getting Started Manual page 158

Configuring T1 and E1 Trunk Modules
IMAgroup profile
nailed-group = 0
group-symmetry-mode = symmetric-operation
version = v1-1
do-version-fallback = no
ignore-lineup = system-defined
lasr = yes
ne-tx-clk-mode = ctc
tx-min-num-links = 1
rx-min-num-links = 1
ima-id = 0
frame-length = 128
diff-delay-max = 25
check-far-end-ima-id = no
expected-far-end-ima-id = 0
far-end-check-frame-length = no
expected-far-end-frame-length = 128
atm-if-delay = 0
tpp-test-link = 0
tpp-test-pattern = -1
tpp-state = disabled
vp-switching-vpi = 15
Parameter
name
active
nailed-group
group-symmetry-mode
version
9-16
Setting
Assigns a name to the IMAgroup profile. Specify a
descriptive name with no embedded spaces.
Specifies whether the profile is enabled or disabled.
Valid values are as follows:
Yes—Specifies that the profile is active.
No—Specifies that the profile is inactive. This is the
default.
Specifies a nailed group number associated with a
physical line, channel, or interface.
Specify an integer from 0 to 1024. The default is 0
(zero).
Specifies if the IMA group to which this link belongs is
set for symmetrical operation. Currently,
symmetric-operation is the only setting supported.
IMA specification version.
Valid values are as follows:
v1-0—ATM Forum IMA version 1.0
v1-1—ATM Forum IMA version 1.1
Stinger® MRT Getting Started Guide