Figure 9-5 Sample Ima Configuration Links - Lucent Technologies Stinger MRT 19 Getting Started Manual

Figure 9-5. Sample IMA configuration links
T1 or E1 Interfaces
Note An IMA group can consist of up to eight line interfaces (ds1-atm profiles).
To configure the ADSL connection to the IMA group, the administrator in this
example proceeds as follows:
1 Verify the presence of the DS1 interfaces.
admin> dir ds1-atm
102 01/24/2002 10:34:23 { shelf-1 trunk-module-2 1 } 1:18:1
108 01/24/2002 17:04:47 { shelf-1 trunk-module-2 2 } 1:18:2
108 01/24/2002 10:34:23 { shelf-1 trunk-module-2 3 } 1:18:3
108 01/24/2002 10:34:23 { shelf-1 trunk-module-2 4 } 1:18:4
108 01/24/2002 10:34:24 { shelf-1 trunk-module-2 5 } 1:18:5
108 01/24/2002 10:34:24 { shelf-1 trunk-module-2 6 } 1:18:6
108 01/24/2002 10:34:24 { shelf-1 trunk-module-2 7 } 1:18:7
108 01/24/2002 10:34:24 { shelf-1 trunk-module-2 8 } 1:18:8
2 Configure the ds1-atm interfaces.
The administrator enables the interfaces for the first three lines and assigns the
group number 851. All three links are initially in UNI mode, and can be
configured individually for connections to separate ATM streams.
admin> read ds1-atm { 1 18 1}
DS1-ATM/{ shelf-1 trunk-module-2 1 } read
admin> set line-config nailed-group = 851
admin> set enabled = yes
admin> write
DS1-ATM/{ shelf-1 trunk-module-2 1 } written
admin> read ds1-atm { 1 18 2}
DS1-ATM/{ shelf-1 trunk-module-2 2 } read
admin> set line-config nailed-group = 851
admin> set enabled = yes
admin> write
DS1-ATM/{ shelf-1 trunk-module-2 2 } written
admin> read ds1-atm { 1 18 3}
DS1-ATM/{ shelf-1 trunk-module-2 3 } read
Stinger® MRT Getting Started Guide
Configuring T1 and E1 Trunk Modules
Configuring T1 or E1 module connections
IMA configuration
Stinger MRT
IMA ATM
group
switch
DSL lines
9-31