Table of Contents
Advertisement
Configuring the SHDSL line interfaces
Checking the status of an SHDSL interface
Parameter
dev-line-state
operational rate
firmware-ver
hardware-ver
network-type
Obtaining statistics about operations
An shdsl-stat profile's physical-statistic subprofile enables administrators to
check interface operations, as in the following example:
admin> list physical-statistic
[in SHDSL-STAT/{ shelf-1 slot-1 10 }:physical-statistic]
line-up-timer = { 0 0 3 }
rx-signal-present = yes
line-quality = 36
up-dwn-cntr = 3
self-test = passed
transmit-power = 10
framer-sync-status = in-sync
code-violations = 17
errored-second = 2
severely-errored-second = 1
losw-second = 1
unavailable-second = 0
loop-attenuation = 10
8-14
Indicates
Current state of the interface, which can be one of the
following:
port-up—Connected to CPE and data can be
transferred.
test—Line is in test mode.
start-up-handshake—Startup handshake is occurring.
start-up-training—Startup training is occurring.
start-up-download—Startup download is occurring.
idle—Line is idle.
down—Line is not currently operational.
out-of-service—Line is out of service.
unknown—Line status is unknown.
analog-loopback—Line is in analog loopback mode.
digital-loopback—Line is in digital loopback mode.
Data rate for this symmetric interface. The data rate is
currently fixed at 1.544 Mbps.
Version number of the SHDSL firmware.
Hardware version of the SHDSL modem.
This lists current Standard Network type. Possible values
are:
annex-a
annex-b
annex-b-anfp
Stinger® MRT Getting Started Guide
Advertisement
Table of Contents
