Chapter 2 Command System
:DISPlay Commands
The :DISPlay commands can be used to set the waveform display mode, persistence time, waveform
intensity, screen grid type and grid brightness.
Command List:
:DISPlay:CLEar
:DISPlay:DATA?
:DISPlay:TYPE
:DISPlay:GRADing:TIME
:DISPlay:WBRightness
:DISPlay:GRID
:DISPlay:GBRightness
:DISPlay:CLEar
Syntax
:DISPlay:CLEar
Description
Clear all the waveforms on the screen.
Explanation
Related
:RUN
Commands
:CLEar
DS1000Z Programming Guide
If the oscilloscope is in the RUN state, waveform will still be displayed.
This command is equivalent to pressing the CLEAR key at the front panel. Sending
the
:CLEar
command can also clear all the waveforms on the screen.
RIGOL
2-29