Table of Contents
Advertisement
7-8
EXS1_INT
8067 Port 1 Interrupt or MPIO3_1 Interrupt
A value of 1 in this bit indicates an interrupt pending from
the SFF-8067 port 1 block or an external interrupt
received on MPIO3(1). The bit goes to 0 when the
interrupt is cleared from MPIO3(1) or cleared from the
SFF-8067 port 1 block.
EXS0_INT
8067 Port 0 Interrupt or MPIO3_0 Interrupt
A value of 1 in this bit indicates an interrupt pending from
the SFF-8067 port 0 block or a external interrupt received
on MPIO3(0). The bit goes to 0 when the interrupt is
cleared from MPIO3(0) or cleared from the SFF-8067
port 0 block.
Register: 0xFE05
Timer 1 Control (T1C)
Read/Write
7
6
T1EXP
T1RUN
0
0
The SYM53C040 includes two built-in timers that run independently of
the microcontroller core. Each timer can be programmed to generate one
of the two possible interrupts to the microcontroller core, as long as these
interrupts are not masked in the
operation will also be suspended if either timer expires and generates an
interrupt to the microcontroller. This frees the internal memory bus to
allow access by the microcontroller after the interrupt awakens the
microcontroller core.
T1EXP
Timer 1 Expired
A value of 1 in the T1EXP bit indicates that the timer has
expired and an interrupt has been generated, if the
T1IEN bit was set at the time the timer expired. The
interrupt can be cleared by setting the T1CLR bit.
T1RUN
Timer 1 Run
A value of 1 in the T1RUN bit allows the timer to advance.
A value of 0 stops timer advancement.
Miscellaneous Registers
5
4
T1CLR
T1PS
Defaults:
0
0
Interrupt Mask (IMR)
3
2
1
R
x
x
x
register. Any DMA
1
0
0
T1IEN
0
7
6
Advertisement
Table of Contents
