Using The Disable Printing Option - HID HDP5000 User Manual

3.9.5.1 Using the Rotate 180 Degrees (Front or Back)
Use this option to change the position of the printed image in relation to the set location of a
card's Magnetic Stripe or smart chip.
Step Procedure
Select the Rotate Front 180 Degrees option to rotate the image on the front of the card by 180
1
degrees when printed.
OR
Select the Rotate Back 180 Degrees option to rotate the image on the back of the card by 180
degrees when printed.
3.9.5.2

Using the Disable printing option

Use this option to disable the printing capabilities of the Printer while still allowing the Printer to
encode cards.
Note: This option is useful to encode or re-encode preprinted cards without wasting additional
time or printing supplies.
Step Procedure
1 Select this option to ensure sending no print data to the Printer (while sending all encoding instructions
according to how they are configured within the software).
This option also allows you to laminate the card.
3.9.5.3 Using the Dual Pass and Invert F-Panel Image options
See Configuring Fluorescent Data using Workbench procedure, page 85.
• Dual Pass option: This refers to the fact that the fluorescing dye can be applied to a
separate panel of HDP InTM Film.
Note: First, the YMC ink is applied to a panel of InTM Film; then, the F and possibly K
are applied to a separate panel. If this is not done, the fluorescent ink tends to mix with
the YMC colors and lose its fluorescent qualities; it also tends to become invisible.
Use the default
dye is used or if selecting
• Invert F-Panel option: This refers to the ability to cause light or white areas of the
image to fluoresce and dark colors to remain dark on the printed card when exposed to
a UV light.
Note: This was requested because the fluorescent dye color is bright when black light
is applied to it. By default, the dark areas of the image will fluoresce on the card and the
lighter or white areas will have no dye applied.
The User can select the Invert F-Panel option to cause the black in the design to show
as dark on the card. This option is recommended if the user is printing a photo.
Page 40 of 101
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
option if using the fluorescent image in places where other
Dual Pass
Invert F Panel
© 2012, 2013 HID Global Corporation. All rights reserved
.
July 2013