Stopping
the Unit
Power Down
Shut Down
CAUTION
CAUTION
CAUTION
Thermo Scientific
Ensure the stop symbol has a box around it, if not use the arrow keys to
navigate to the symbol.
Stop Symbol
Press
. The unit will stop and the stop symbol will turn into a start
symbol (
).
NOTE When quickly restarting refrigerated units, the compressor may
take up to 10 minutes before it starts to operate.
Press
. The pump and, if applicable, the refrigeration will stop.
The thermostat's screen will go blank. The blue LED will illuminate.
NOTE When quickly restarting refrigerated units, the compressor may
take up to 10 minutes before it starts to operate.
Place the circuit protector on the rear of the thermostat to the O
position.
On refrigerated units, place the circuit protector on the rear of the bath
to the O position.
Using any other means to shut the unit down can reduce the life
of the compressor.
Always turn the unit off and disconnect it from its supply voltage
before moving the unit.
The circuit protector(s) located on the rear of the component(s) is
not intended to act as a disconnecting means.
SP1
+020.00
+024.29 °C
Internal Temp..
Section 4 Operation
Menu
in
4-19