Remaining Battery - Panasonic LUMIX DC-TZ200 Operating Instructions Manual

Notes on charging time
When using the AC adaptor (supplied)
Charging time
• The charging time indicated above is the time required for charging in case when the
battery is completely used up. The time required for charging differs depending on
conditions of battery usage. Charging takes longer in cases when temperatures are
either high or low and when the battery has not been used for a long period of time.
• The time required for charging through the computer varies depending on the power
supply capacity of the computer.
●
Do not use any other USB connection cables except the supplied one. Doing so may cause
malfunction of the camera.
●
Do not use any other AC adaptors except the supplied one.
●
Do not use a USB extension cable.
●
The AC adaptor (supplied) and the USB connection cable (supplied) are dedicated accessories of
this camera. Do not use them for other devices.
●
Remove the battery after use. (The battery will be exhausted if left for a long period of time after
being charged.)
●
If there is any trouble related to the electrical outlet (i.e. power failure), charging may not complete
properly. Disconnect the USB connection cable (supplied) and reconnect it to the camera.

Remaining battery

50 p
23
Remaining battery (only when using battery)
If the battery mark flashes red, recharge or replace a fully charged
battery.
Approx. 190 min.
(flashes red)
Preparations
Charging battery