Table of Contents
Advertisement
■
Recording
Striping or flicker may appear under lighting such as fluorescent lighting and LED lighting
fixture.
• This is characteristic of MOS sensors which serve as the camera's pickup
sensors. This is not a malfunction.
• If you are taking still pictures using the electronic shutter, the striping may be
reduced by setting a slower shutter speed.
• When noticeable flicker or striping is seen under lighting such as a fluorescent
or LED lighting fixture in the motion picture recording mode, you can reduce
the flicker or striping by setting up [Flkr Decrease]
shutter speed. It is possible to select a shutter speed from [1/50], [1/60],
[1/100], or [1/120]. You can set the shutter speed manually in the Creative
Video Mode.
(→77)
Cannot record pictures. The shutter will not operate immediately when the shutter button is
pressed.
• When [Focus/Release Priority] is set to [FOCUS], the camera will not record until proper focusing is
achieved.
(→184)
Recorded pictures look white.
• Lens is dirty (fingerprints, etc.).
→ Turn the camera on to extract lens barrel, and clean lens surface with a soft, dry cloth.
Recorded pictures are too bright/too dark.
• AE Lock
(→99)
Some pictures are taken when I press the shutter button just once.
• Drive Mode is set to other than [Single].
• Bracket recording is set.
Focus not aligned correctly.
• Subject outside of focus range.
• [Focus/Release Priority] is set to [RELEASE].
• [Shutter AF] is set to [OFF].
• AF Lock
(→99)
• If there are fingerprints or dirt on the lens, the focus may be set to the lens and not the subject.
Recorded pictures are blurred. The stabiliser function ineffective.
• Shutter speed is slower in dark locations and the stabiliser function is less effective.
→ Use a tripod and the self-timer
293
is set inappropriately.
(→127)
(→182)
is set inappropriately.
(→126)
(→59)
(→179)
and fixing the
(→123)
(→184)
when using a slower shutter speed.
Others
Q&A Troubleshooting
Advertisement
Table of Contents
