Download  Print this page

Panasonic LUMIX DC-TZ200 Operating Instructions Manual Page 148

Hide thumbs


If the surrounding temperature is high, or a motion picture is recorded continuously, [
displayed and recording may be stopped halfway through. Wait until the camera cools down.
Note that if you perform operations such as zoom, using buttons or dials, while recording a motion
picture, operation noise may be recorded.
If Extra optical zoom is used before pressing the motion picture button, these settings will be
cleared, and the recordable area will be changed significantly.
If the aspect ratio is different for still pictures and motion pictures, the angle of view will change
when starting to record a motion picture.
When you set [Rec Area] to [
The zoom speed will be slower than normal during motion picture recording.
Depending on the type of the card, the card access indication may appear for a while after
recording motion pictures. This is not a malfunction.
ISO sensitivity is set to [AUTO] (for motion pictures) while a motion picture is being recorded. You
can set ISO sensitivity and record motion pictures in Creative Video Mode.
The below-mentioned motion picture recording modes are set in the following cases:
[Clear in Backlight]
[Clear Nightscape], [Artistic Nightscape],
[Handheld Night Shot], [Clear Night Portrait]
This function is not available in the following cases:
• [Glistening Water], [Glittering Illuminations], [Soft Image of a Flower] (Scene Guide Mode)
• [Rough Monochrome], [Silky Monochrome], [Soft Focus], [Star Filter], [Sunshine] (Creative
Control Mode)
• When [Post Focus] is set
• When using [Time Lapse Shot]
• When using [Stop Motion Animation]
], the angle of view setting used for recording motion pictures is
Selected Scene Guide Mode
Recording motion pictures
Recording Motion Picture/4K Motion Picture
Recording mode at the time of
recording motion pictures
Portrait Mode
Low Light Mode
] is


Table of Contents

This manual is also suitable for:

Lumix dc-tz202Lumix dc-zs200

Comments to this Manuals

Symbols: 0
Latest comments: