Panasonic MN103S User Manual page 35

TQFP 48
Name I/O
Pin No.
ADIN00 6 Input
ADIN01 7
ADIN02 8
ADIN03 9
ADIN04 11
ADIN05 13
ADIN06 14
ADIN07 15
ADIN08 16
ADIN09 17
ADIN10 18
ADIN11 19
ADIN12 20
ADIN13 21
ADIN14 22
ADIN15 23
IRQ00 1 Input
IRQ01 2
IRQ02 3
IRQ03 4
IRQ04 34
IRQ05 35
IRQ06 36
IRQ07 37
IRQ08 38
PWM00 64 Output
PWM01 66
PWM02 68
PWM10 70
PWM11 72
PWM12 74
NPWM00 65 Output
NPWM01 67
NPWM02 69
NPWM11 71
NPWM12 73
NPWM13 75
TCPOUT 5 Input
TEST1 24 Input
TEST2 25
TEST3 26
VPPEX is power supply for flash EEPROM rewriting. Its potential should be the same as
VDD3. In mask ROM version, VPPEX is N.C; however, it is recommended to connect to
VDD3 for compatibility with flash EEPROM version.
..
..
Other Function
P90
P91
P92
P93
P94
P95
P96
P97
PA0
PA1
PA2
PA3
PA4
PA5
PA6
PA7
P80
P81
P82
P83
P10
P11
P12
P13
P14
P52
P54
P56
P62
P64
P66
P53
P55
P57
P63
P65
P67
-
-
Function
Analogue input pin Analogue input pins for 16-channel, 10-bit 3
A/D converters.
These can be used as normal I/O pins when
these are not used as analog input.
External interrupt External interrupt input pins.
pin The valid edge can be selected. Set whether
both edges are detected or not by the edge
detection register (IRQEDGESEL). When it is
set not to detect both edges, select rising
edge, falling edge, H level, or L level by the
external interrupt condition specification reg-
ister (EXTMD0 and EXTMD1). When it is set
to detect both edges, select rising edge by
the external interrupt condition setting regis-
ter.
Motor control Motor control 3-phase PWM signal output
PWM signal out- pins.
put pin Select PWM signal output pins by the P5MD
and P6MD registers and set output mode by
the P5DIR and P6DIR registers.
These can be used as normal I/O pins when
these are not used as PWM signal output
pins.
Motor control Motor control 3-phase PWM signal revers
PWM signal output pins.
reverse output pin Select PWM signal output pins by the P5MD
and P6MD registers and set output mode by
the P5DIR and P6DIR registers.
These can be used as normal I/O pins when
these are not used as PWM signal output
pins.
Test signal input Test signal input pin. Fix at VSS.
Test signal input Test signal input pins built-in pull-up resistor.
Pull-up with resistor of OPEN or 1 kΩ.
Chapter 1
Overview
Description
Pin Description I - 15