Panasonic MN103S User Manual page 294

Chapter 9
16-bit Timer
Setting PWM Output
Select the timer output waveform selection flag of the timer compare/capture mode register.
When TM8AIO, TM9AIO, TM10AIO, TM11IO0 and TM11IO1 pins are used,
Set when TMnBC and TMnCA match, and reset when TMnBC and TMnCB match.
Set when TMnBC and TMnCA match, and reset when TMnBC overflows.
When TM8BIO, TM9BIO and TM10BI0 pins are used,
Set when TMnBC and TMnCB match, and reset when TMnBC and TMnCA match.
Set when TMnBC and TMnCB match, and reset when TMnBC overflows.
Timer pins polarity selection is a flag which is set the condition of the pin output. When it is set to "0", the initial
value is "L", and when it is set to "1", the initial value is "H" and the polarity at the outputs is inverted. The regis-
ters and flags set to the pins at output are shown below.
Table:9.8.3 Selecting Timer Output Waveform and Timer Pin Polarity
TM8AIO
TM8BIO
TM9AIO
TM9BIO
TM10AIO
TM10BIO
TM11IO0
TM11IO1
IX - 58 PWM Output
Timer output waveform selection
TM8MDA(TMAO1-0)
TM8MDB(TMBO1-0)
TM9MDA(TMAO1-0)
TM9MDB(TMBO1-0)
TM10MDA(TMAO1-0)
TM10MDB(TMBO1-0)
TM11MDA(TMAO1-0)
TM11MDA(TMAO1-0)
Timer pin polarity selection
TM8MDA(TMAEG)
TM8MDB(TMBEG)
TM9MDA(TMAEG)
TM9MDB(TMBEG)
TM10MDA(TMAEG)
TM10MDB(TMBEG)
TM11MDA(TMAEG)
TM11MDA(TMAEG)