Terminal Module Tm150 - Siemens Sinamics s120 Commissioning Manual

LED Color Status
Green/
orange
Flashing
or
light
red/
2 Hz
orange
The parameters for activating component recognition using LEDs can be taken from the following reference:
1)
Reference: /LH1/ SINAMICS S120/S150 List Manual
4.1.4.4

Terminal Module TM150

Table 4- 49 Meaning of the LEDs at the Terminal Module TM150
LED Color
–
Green
Orange
READY
Red
Green/
Red
Green/
orange
or
red/
orange
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
Description, cause
Component recognition via LED is activated
Note:
Both options depend on the LED status when component
recognition is activated.
State Description, cause
Off Electronic power supply is missing or outside permissible
tolerance range.
Continu- The component is ready for operation and cyclic DRIVE-
ous light CLiQ communication is taking place.
Continu- DRIVE-CLiQ communication is being established.
ous light
This component has at least one fault.
Continu- Note:
ous light
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Flashing Firmware is being downloaded.
light
0.5 Hz
Flashing Firmware has been downloaded.
light Wait for POWER ON.
2 Hz
Component recognition via LED is activated (p0154).
Flashing Note:
light
Both options depend on the LED status when module
2 Hz
recognition is activated via p0154 = 1.
4.1 Diagnostics via LEDs
Remedy
. -
1)
Remedy
Check power supply
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
Diagnostics
337