Siemens Sinamics s120 Commissioning Manual page 284

Commissioning
3.21 Temperature sensors for SINAMICS components
Module
Active Line Module
Smart Line Module
Basic Line Module
Motor Module
Cable for connection to direct measurement systems: Article number 6FX.002-2CB54-....
1)
Commissioning information
The index [0...n] used in the following identifies either the motor data set or the encoder data
set.
SMC10/SMC20
You can use the STARTER screen (\messages and monitoring \ motor temperature) to
parameterize the motor temperature evaluation via SUB-D socket X520.
SMC30 (as of article number 6SL3055-0AA00-5CA2)
In addition to temperature evaluation via terminal X531 (temperature channel 1), this module
also has temperature evaluation at SUB-D socket X520 (temperature channel 2).
In the default setting (p0600 = 1 "Temperature via encoder 1" and p0601 = 2 "KTY" or p0601
= 6 "PT1000"), the temperature is evaluated via the first temperature channel. The
temperature sensor is connected to terminal X531 on the SMC30. The temperature is shown
via r0035.
284
Interface Pin
Booksize 1
X21 (terminal) 2
Chassis 4
X41 (terminal) 3
Booksize 1
X21 (terminal) 2
Chassis 4
X41 (terminal) 3
Booksize 1
X21 (terminal) 2
Chassis 4
X41 (terminal) 3
Booksize 1
X21/X22 (terminal) 2
The following ap- 4
plies to chassis: 3
X41 (terminal)
Signal name Technical specifications
+Temp Active Line Module temperature
-Temp sensor
Temperature switch type: bimetal-
+Temp
lic switch with NC contact
-Temp
+Temp Active Line Module temperature
-Temp sensor
Temperature switch type: bimetal-
+Temp
lic switch with NC contact
-Temp
+Temp Basic Line Module temperature
-Temp sensor Temperature switch type:
bimetallic switch with NC contact
+Temp
-Temp
+Temp Temperature sensor
-Temp KTY84–1C130/PTC/PT1000
Bimetallic switch with NC contact:
+Temp
Alarm and timer (only for tempera-
-Temp
ture evaluation via MM)
PT100 temperature sensor
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
STARTER Commissioning Manual