Braking Module In Booksize Format; Smart Line Module Booksize Compact Format - Siemens Sinamics s120 Commissioning Manual

Diagnostics
4.1 Diagnostics via LEDs
4.1.2.7

Braking Module in booksize format

Table 4- 20 Meaning of the LEDs on the Braking Module booksize
LED Color State
READY – Off
Green Continuous
light
Red Continuous
light
DC LINK – Off
Green Flashing
light
4.1.2.8

Smart Line Module booksize compact format

Table 4- 21 Meaning of the LEDs on the Smart Line Module booksize compact
State
RDY DC LINK
Off Off
Green –
Orange
Red
Orange Orange
Red –
Green/red –
(0.5 Hz)
320
Description, cause
Electronic power supply is missing or outside permissible
tolerance range.
Component deactivated via terminal.
Component is ready to operate.
Enable signal missing (input terminal)
Overtemperature
Overcurrent trip
I t monitoring responded
2
Ground fault/short circuit
Note:
In the event of an overtemperature, the error cannot be
acknowledged until after a cooling down time.
There is no DC link voltage or the electronic power supply is
missing or outside permissible tolerance range.
Component not active.
Component active (DC link discharge via braking resistor in
progress).
Description, cause
Electronic power supply is missing or outside permissible
tolerance range.
The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-
CLiQ communication is taking place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Firmware is being downloaded.
Remedy
–
–
–
Check the line voltage
–
Remedy and acknowledge
fault
–
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
Remedy
–
–
Diagnose fault (via
output terminals) and
acknowledge it (via
input terminal)
–
–