Siemens Sinamics s120 Commissioning Manual page 289

SME20
The evaluation of KTY, PT1000, or PTC temperature sensors can be parameterized using
the STARTER screen (Messages and monitoring > Motor temperature):
● Temperature sensor selection (≙ p0600[0...n]): Selection of the source to which the SME
module is assigned (temperature sensor via encoder (1, 2 or 3), temperature sensor via
BICO interconnections or temperature sensor via Motor Module).
● Temperature sensor type (≙ p0601[0...n]): Sets the sensor type for motor temperature
monitoring.
Image 3-97
SME120/SME125
For modules with several temperature sensor connections (SME modules), the temperature
sensor is selected depending on encoder data set n via parameters
p4601[0...n]..p4603[0...n]. A maximum of three motor temperature sensors can be evaluated
simultaneously via terminal X200.
The parameterization of the motor temperature evaluation via terminal X200 must be
performed in the expert list as follows:
● p0600[0...n]: Selection of the encoder (1, 2 or 3) to which the SMC used for the
temperature evaluation is assigned, n = motor data set.
● p0601[0...n] = 10 (evaluation via several temperature channels), n = motor data set.
● p4601[0...n]-p4603[0...n]: Selection of the temperature sensor type of temperature
channels 2-4, depending on encoder data set n.
Only temperature channels 2-4 are available at terminal X200.
● Parameter r4620[0...3] Motor temperatures SME
Displays the current temperatures in the motor, measured via an SME120 or SME125.
The indices mean:
[1] = SME temperature channel 2 / motor temperature sensor 2
[2] = SME temperature channel 3 / motor temperature sensor 3
[3] = SME temperature channel 4 / motor temperature sensor 4
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
3.21 Temperature sensors for SINAMICS components
Selection of temperature sensor for SME20 modules
Commissioning
289