Terminal Module; Terminal Module Tm15 - Siemens Sinamics s120 Commissioning Manual

LED Color Status
Green/ Flashing
orange light
or
Red/
orange
4.1.4

Terminal Module

4.1.4.1

Terminal Module TM15

Table 4- 46 Meanings of the LEDs on the Terminal Module TM15
LED Color
READY -
Green
Orange
Red
Green/red
Green/
orange
or
Red/orange
The parameters for activating component recognition using LEDs can be taken from the following reference:
1)
Reference: /LH1/ SINAMICS S120/S150 List Manual
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
Description, cause
Component recognition via LED is activated (p0154 = 1).
Note:
Both options depend on the LED status when component
recognition is activated.
Status
Off The electronics power supply is missing or outside the per-
missible tolerance range.
Continuous The component is ready for operation. Cyclic DRIVE-CLiQ
light communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous This component has at least one fault.
light
Note:
The LED is activated irrespective of whether the correspond-
ing messages have been reconfigured.
Flashing Firmware is being downloaded.
light 0.5 Hz
Flashing Firmware download is complete. The system waits for
light 2 Hz POWER ON.
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated.
Description, cause
.
1)
Diagnostics
4.1 Diagnostics via LEDs
Remedy
–
Remedy
–
–
–
Remove and
acknowledge the
fault.
–
Carry out a POWER
ON.
–
335