Siemens Sinamics s120 Commissioning Manual page 113

5. Right-click the bus node entry to open the shortcut menu "Edit Ethernet node ...".
– In the selection window that opens "Edit Ethernet node" you will also see the MAC
6. Under "Set IP configuration", enter the IP address that you selected (e.g. 169.254.11.33)
and the subnet mask (e.g. 255.255.0.0).
7. Click the "Set IP configuration" button.
– The data transfer is confirmed.
8. Click the "Update" button.
– The bus node is identified as drive unit.
– The address and the type are specified.
In the "Edit Ethernet node" selection window you can also assign a device name to the
drive unit that has been detected.
9. In the "Device name" field, enter the name that you have selected.
Note
ST (Structured Text) conventions must be satisfied for the name assignment of IO
devices in PROFINET (SINAMICS components). The names must be unique within
PROFINET. Rules for assigning names:
• Other than "-" and ".", no special characters (such as accented characters, spaces,
• The device name must not begin or end with the "-" character.
• The device name must not begin with a number.
• Maximum total length of 240 characters (lowercase characters, numbers, hyphen, or
• A name component within the device name, e.g. a string between two periods, must
• The device name must not take the form n.n.n.n (n = 0..999).
• The device name must not begin with the character sequence "port-xyz" or "port-xyz-
10.Click the "Assign name" button.
– The data transfer is confirmed.
11.Click the "Update" button.
– The bus node is detected as drive unit and is consecutively numbered.
– The address, device name and the type are specified.
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
address.
brackets) are permitted in the name of an IO device.
period)
not exceed 63 characters.
abcde" (a, b, c, d, e, x, y, z = 0..9).
Commissioning
3.3 STARTER commissioning tool
113