Unipulse f395 Operation Manual page 99

14.Waveform Editing
4. Axis register key - - - - - - - - - Carries out axis registration.
5. UP key - - - - - - - - - - - - - - - Goes to the waveform sampling item selection screen.
6. Waveform save key - - - - - - - Goes to the waveform save screen.
7. Y-axis scaling up/down key- - Scales up/down in the Y-axis direction on the basis of
8. X-axis scaling up/down key - Scales up/down in the X-axis direction on the basis of
9. Axis return key - - - - - - - - - - Returns the axis setting as registered.
10. Cursor change keys - - - - - - Changes the cursor between the right and left.
11. High/low limit waveform change key- - - -
12. Cursor right/left key - - - - - - Moves the cursor in the X-axis direction dot by dot.
13. Area head/end key - - - - - - - Moves the cursor to the head/end of the area.
14. Screen move keys - - - - - - - Moves the screen on the X-axis by 1/8 of the distance
15. Graph area - - - - - - - - - - - - Moves the cursor to the pressed location in the graph
16. Reading display- - - - - - - - - Displays the cursor reading.
85
Temporarily registered waveform data cannot be used in the Waveform
Comparison mode as it is, and is also cleared when the power is
turned off.
By storing waveforms under "Waveform Save" (See "14-4-4.
Waveform Save" P91.), these can be used in the Waveform
Comparison mode, and are also backed up.
Changes the set value of the Y-axis start point / Y-axis
scaling / X-axis start point / X-axis scaling according
to the display.
Since the graph is first displayed on the screen by the
registered axis setting, the influence of changing the
axis setting by waveform reading or editing is
eliminated.
(See "14-4-4. Waveform Save" P91.)
the Y-axis start point.
the X-axis start point.
The selected cursor becomes white, and the reading is
also displayed in white. The reading is enclosed with a
box.
Changes the selected waveform to a high/low limit
waveform.
between the start point and end point of the graph, and
on the Y-axis by 1/4 of the distance between the start
point and end point of the graph.
If you keep pressing the key, continuous movement
will result.
area.
Those other than the screen move keys enter into the
cursor moving area.
One of on the right side of the numerical value
shows 0.25 (decimals).