Waveform Drawing Procedures; Multi-Hold Procedures - Unipulse f395 Operation Manual

1.Outline of the F395

1-2. Waveform Drawing Procedures

The F395 can provide waveform displays of signals from a strain gauge type sensor and
displacement sensor. The waveform display procedures are as follows.
(See "7-4. X/Y-axis Setting by Operation Mode and Input CH" P41.):
1. Connect a strain gauge type sensor (and displacement sensor) with the F395.
2. Perform calibration. (See "5. Methods of Calibration" P31.)
3. Set each parameter for waveform display.
4. Check to see if a waveform is displayed for the set conditions.

1-3. Multi-Hold Procedures

In the Multi-Hold mode, necessary points are detected in the displayed waveform to
make a judgment such as a High/Low Limit Comparison. Up to 32 channels of Hold
types, High and Low Limits, etc., can be stored, which can be switched by external
signals. The procedures for using the Multi-Hold function are as follows:
1. Check to see if a waveform is displayed in accordance with the waveform drawing
2. Select a hold function so that necessary points in the waveform can be held. (See "10-
3. Carry out Multi-Hold settings. (See "16-2. Each Setting Item" P103.)
4. Select the channel number(s) you want to control externally. (See "4-3. Control
5. Input T/H and H/M signals in accordance with the selected hold function, and check to
3
(See "4-1-1. Analog Input / Output Connection" P21.)
(See "9. Method of Starting Measurement" P43, and "16-2-9. Level Axis Select /
Waveform Start Level / Waveform Termination Level / Hold Start Level" P113.)
procedures. (See "1-2. Waveform Drawing Procedures" P3.)
3. Hold Functions" P48.)
Connector Connection" P25.)
see if operation is performed as set. (See "10-3. Hold Functions" P48.)