Unipulse f395 Operation Manual page 107

15.Waveform Reading
The measured value of the cursor-placed waveform is displayed as the present value.
At this time, the High and Low Limits (X/Y-axis) are also displayed. Details of the
numerical display are as follows. (The X-axis reading display is the same as in "14-4.
Waveform Editing" P84.)
93
10.00 cm
X-axis readings
10.00 cm
10.00 cm
・ Even if the cursor seems to be placed at the "+" mark, a different point
may actually be read depending on the display scaling. For confirming
accurate values, press the "Hold Jump" key. (See "15-1-4. Hold Jump
Function" P95.)
・ In the Pulse Hold / Hysteresis 2 mode, Y-axis High and Low Limits are
displayed only when the cursor is placed at the "+" mark. In other cases,
"----" is displayed.
・ In the Waveform Comparison / Waveform and Displacement
Comparison mode, Y-axis High and Low Limits are displayed as "----"
where High and Low Limit Waveforms are not available.
・ In the High-Low Relative mode, if Y-axis High and Low Limits exceed ±
10000, "--HI--" and "--LO--" are displayed, respectively.
・ In the Hysteresis / Hysteresis 2 / Waveform and Displacement
Comparison mode, the display of the X-axis High / Low Limit reading
section changes according to the Displacement High-Low Mode setting
(See "16-2-8. Displacement High-low Mode / Displacement High Limit /
Displacement Low Limit / Displacement Hold High Limit / Displacement
Hold Low Limit" P110.) as follows
Hold Value: Displacement Hold High / Low Limit
Peak Value: Displacement High / Low Limit
Both: "+" Mark Section: Displacement Hold High / Low Limit
Others:
・ Be aware that the sampled waveform display is not updated when
the Waveform Reading screen is displayed.
・ Display of X-axis High and Low Limits is not available in the Multi-
Hold / Waveform Comparison mode.
High limit 100.0kN
100.0kN
Present value
Low limit 100.0kN
Displacement High / Low Limit
Y-axis readings