Rejected Waveform Clear; Y-Axis Start Point; Y-Axis Scaling - Unipulse f395 Operation Manual

15.Waveform Reading

15-3. Rejected Waveform Clear

The oldest rejected waveform is cleared.

15-4. Y-axis Start Point

Set the Y-axis start point (lower end) of the graph.
Y-axis Start
Point

15-5. Y-axis Scaling

Set the Y-axis scale of the graph. Select scaling so that the input waveform is properly
displayed.
97
・ Up to the "2nd Last Wave" are stored in the Hysteresis mode.
・ NG waveforms are automatically updated upon their occurrence.
Therefore, if the displayed waveform is automatically cleared, the
display is changed to the waveform set at that time.
The operation is executed by pressing the
MODE Read Wave
→
Setting range: -9999 ~ 9999 (Not including the decimal point.)
MODE Read Wave
→
Setting item: 100% / 50% / 20% / 10% / 5% / 2% / 1%
MODE Read Wave
→
Y-axis
scale
key.
→ NG Wave CLR.
Y StartPoint
→
Y Scale
→