Unipulse f395 Operation Manual page 125

16.Code Setting
1. Hold value
High/Low Limit Judgments are made with respect to the indicated value. When the
operation ch is switched, the results are accumulated at the Judgment output signal ~ 2
(in the Hysteresis / Hysteresis 2 mode). The following two types of High / Low Limit
setting are used.
Displacement Hold High Limit / Displacement Hold Low Limit
In the Hysteresis / Hysteresis 2 mode
In the Waveform and Displacement Comparison mode
Indicated value
Displacement
Displacement
The displacement hi limit is not turned on due to hold.
Also, the output has no connection with the COMPLETE signal.
111
Setting range: 0 ~ 9999 (Not including the decimal point.)
MODE → Code Set → Judgment: PAGE → DPM Hold HI /
MODE → Code Set → Judgment: DPM Hold HI /
Displacement Hold
Low Limit
High Limit
OK
Low Limit
DPM Hold LO
DPM Hold LO
Displacement Hold
High Limit
Displacement
Output Logic
OFF
ON