Character Length; Parity; Terminator; Communication Mode - Unipulse f395 Operation Manual

18-3-2. Character Length

Set the data and stop bits out of the following.
(Expression is in the order of data-stop bits.)
Setting item: 8bit-1stop / 7bit-1stop / 8bit-2stop / 7bit-2stop

18-3-3. Parity

Set the parity bit out of the following.
Setting item: None / Odd / Even

18-3-4. Terminator

Set the terminator out of the following.
Setting item: CR+LF / CR

18-3-5. Communication Mode

Set the communication mode out of the following.
(For each mode, see "18-4-12. Automatic Transmission Mode" P149.)
Setting item: Normal / Continuity / Hold Point
Request
These settings are determined when the power is on. Therefore, if any
setting is changed, turn the power off and then on again.

18-3-6. SI/F Hold Point Transmission

Set whether or not to output hold data by SI/F automatic printing after completion of
sampling.
Setting item: Transmit / Not Transmit
When the hold function is used at the ±OVER and ADC ± OVER, the
hold value will be ±9999. While instead of ±OVER or ADC ± OVER,
the ± 9999 will be transferred via SI/F interface.

18-3-7. SI/F Hold Point

Set the ordinal number of hold points to output for SI/F automatic printing.
Setting range: 1 ~ 9
18.Interface
134