7．Measurement Operation Functional Settings; Operation Mode; Sampling Rate - Unipulse f395 Operation Manual

7. Measurement Operation Functional Settings

7-1. Operation Mode

Set the Operation Mode according to the working conditions from the following.
When the mode is changed to Hysteresis / Waveform and Displacement Comparison /
Hysteresis 2, if the sampling rate has been set at 4kHz, the sampling rate is automatically
changed to 2kHz. At the same time, the buzzer beeps.

7-2. Sampling Rate

Select the sensor signal reading speed from the following.
The relationship between the sampling rate (frequency) and reading speed is as follows:
Setting item: Multi-Hold / Wave Comp. / Hysteresis / Wave&Displace / Hysteresis2
MODE → Operation Mode
Setting item: 4 kHz / 2 kHz / 1 kHz / 500 Hz / 200 Hz / 100 Hz
(4kHz cannot be set in the Hysteresis / Waveform and Displacement Comparison /
Hysteresis 2 mode.)
MODE Operation Mode
→
Sampling rate
4kHz
2kHz
1kHz
500Hz
200Hz
100Hz
7.Measurement Operation Functional Settings
→ Operation Mode
Sample Rate
→
Reading speed
4000 times/sec.
2000 times/sec.
1000 times/sec.
500 times/sec.
200 times/sec.
100 times/sec.
40