Unipulse f395 Operation Manual page 23

2.Name and Function of Each Part
3. X-axis (displacement) display section
Displays X-axis measured values such as displacement in the Hysteresis / Hysteresis 2 /
Waveform and Displacement Comparison mode, and also displays error messages when
measurement errors occur.
(See "7-4. X/Y-axis Setting by Operation Mode and Input CH" P41, and "19. Error
Messages" P150)
4. Displacement high and low limit set values
Displays the displacement comparison values of the ch (operation ch) set by external
input in the Hysteresis / Hysteresis 2 / Waveform and Displacement Comparison mode.
Displacement comparison values that are displayed vary depending on the Displacement
High-Low Mode.
(See "16-2-8. Displacement High-low Mode / Displacement High Limit / Displacement Low
Limit / Displacement Hold High Limit / Displacement Hold Low Limit" P110.)
5. Lithium battery alarm
Displayed when the lithium battery requires replacement. (Normally, nothing is
displayed.)
If this alarm lights, replace the lithium battery in good time. (The life of the lithium
battery is approx. 7 years, which depends on the working environment.) For replacement
of the battery or handling of interchangeable batteries, contact us.
6. Status display section
ⅰ Status display
9
Status
Thinning-out
WARNING
Mode
Hold Value Displacement Hold High/Low Limit
Peak / Both Displacement High/Low Limit
WAIT S : Waiting for start.
WAIT 2 : Waiting for the rising edge of start/level.
WAIT L : Waiting for level.
SAMPLE : In sampling.
HIS GO : In hysteresis go sampling
HIS RT : In hysteresis return sampling.
COPY : In waveform copy
STOP : Waiting for start.
Display Color
Yellow
Red
Comparison value