Specifying Sampled Waveform Access Channels - Unipulse f395 Operation Manual

18.Interface

18-4-3. Specifying Sampled Waveform Access Channels

139
Ｗ ５ １ Ｓ Ｐ ０ ０
Host
Return
Ｗ ５ １ Ｓ Ｐ ０ ０
F395
Set value
0 ~ 15
80
81
82
83
90
91
92
Other values
・ In the Hysteresis mode, "80" indicates the last go and return rejected
waveforms, and "81" indicates the 2nd last go and return rejected
waveforms.
・ In modes other than the Waveform Comparison mode and Waveform
and Displacement Comparison mode, W52, W54, and W55 cannot
be used after specifying W51SP0091. (Also, no return is made.)
Input a set value out of the following table.
(Present set value)
Registered waveforms for comparison
(Specify channel No.)
Last Rejected Waveform
2nd Last Rejected Waveform
3rd Last Rejected Waveform
4th Last Rejected Waveform
Latest sampled waveform
Waveform for comparison being used
for measurement
High/Low Limit Waveform obtained
by waveform sampling
Do not use.
Terminator
Terminator