Parameter Copy; Select Analog Ch - Unipulse f395 Operation Manual

16-2-2. Parameter Copy

The value set at one channel is copied to another channel as is by this operation.
Setting range: 0 ~ 32
MODE
The source of copy is the channel currently set under "Channel Number Selection". For
copying the value set at one channel to all channels, set at 32ch.
All items set in Code Setting can be copied.
If "32" is set under "Channel Number Selection", you will hear a beep
which indicates a failure in copy.
Set a value other than "32" under "Channel Number Selection", and
execute again.

16-2-3. Select Analog CH

Set the analog input CH used on the Y-axis.
Setting item: CH1 / CH2
MODE
The setting is limited depending on the set Operation Mode.
(See "7-4. X/Y-axis Setting by Operation Mode and Input CH" P41.)
Code Set → Basic: Parameter Copy
→
→ Code Set → Basic: Select CH
16.Code Setting
104