Hold Operation; Operation And Operating Method - Unipulse f395 Operation Manual

13.Waveform Comparison / Waveform and Displacement Comparison Mode

13-7. Hold Operation

In the Waveform Comparison / Waveform and Displacement Comparison mode, any one
of hold operations: sample hold, peak hold, and valley hold can be executed
simultaneously. Simultaneously with the Waveform Comparison Judgment, a High/Low
Limit Judgment can also be made with the hold point.

13-7-1. Operation and Operating Method

Example:
When peak hold is executed
START
T/H
STOP
COMPLETE
A High/Low Limit Judgment is made with the hold point only when the
HI-HI/LO-LO Mode setting (See "16-2-7. High Limit / Low Limit / HI-HI/
LO-LO Mode / HI-HI Limit / LO-LO Limit" P109.) is "Hold". (If the setting
is "Sampling Value", real-time judgments on the sampling value will
result.)
Hold reset
Waveform
Start Level
OFF
ON
OFF
ON
OFF
ON
OFF
ON
* For the delay time between each signal and processing, and the pulse width of each
signal, see "13-6. Timing in the Waveform Comparison / Waveform and Displacement
Comparison Mode" P76. Also, for the T/H signal and High/Low Limit Judgment output,
see "10-3-1. Sample Hold" P49, "10-3-2. Peak Hold" P50, and "10-3-3. Valley Hold" P51.
Detection/hold period and
waveform comparison period
Indicated value
Sensor input value
Inputting of the STOP
signal, excess of 2048
points, or crossing over
the waveform
termination level (when
the signal "Waveform
terminal level operation"
is ON)
78