16．Code Setting; Method Of Setting The Operation Ch - Unipulse f395 Operation Manual

16. Code Setting
Set the items used in each Operation Mode only the items necessary for the set
Operation Mode are displayed.
(See "3-2. Setting Mode Tree Chart" P15.)

16-1. Method of Setting the Operation ch

The operation ch can be set by external signals or the Auto Code Up function. Also, an
interval of approx. 40msec is required for switching the operation ch. (Switching within
approx. 40msec is ineffective. Operation ch switching processing is performed approx.
40msec after switching.)
1. Setting by external signals
(Processed by addition of the numerical value at the " ~ " part of CODE ~ .)
・ In the Waveform Comparison / Waveform and Displacement Comparison mode, the
・ The operation ch is taken in by double reading. For avoiding the delay at change-time,
2. Setting by the auto code up function
The operation ch can automatically be updated during sampling by using the Auto Code
Up function.
・ The Auto Code Up mode is executable when the Multi-Hold / Hysteresis mode is set.
・ If the Auto Code Up (See "16-2-5. Auto Code Up / Code Up Point" P107.) is set to
Operation
CODE16 CODE8
ch
0 0
1 0
2 0
3 0
・ ・ ・ ・
・ ・
31 1
operation ch of 16 or more is totally processed as 15ch.
use the STROBE signal, change the code beforehand, and turn off STROBE by the
timing of changing the operation ch.
"ON" on the operation ch at which sampling starts, the sampling is brought into Auto
Code Up mode.
CODE4 CODE2
0 0 0
0 0 0
0 0 1
0 0 1
・ ・ ・ ・ ・ ・
・ ・ ・
1 1 1
16.Code Setting
CODE1
0
1
0
1
CODE1 ~ 16
・ ・
・
0：Open
1
1：Short
100